As you may have seen in my 'broken down post' my light bracket failed. So here's my new ones that I had made this week.
Ok they look good but fitting them to my Mk Indy was a >:( >:( >:( >:( >:(
Mk use poxy little 6mm inserts into the chassis rail and on one side it just turned!! So I had to hacksaw the bolt off. Going to have a relax in the bath and may be tomorrow I will get the drill out and drill a 6.3mm hole thought both sides of that 1" box section :o I'm sure it will be fine???!!!
Here's the brackets;
(http://s10.postimage.org/4vnqk7n7p/DSCF8380.jpg) (http://postimage.org/image/4vnqk7n7p/)
(http://s18.postimage.org/ozmdv0dyt/DSCF8381.jpg) (http://postimage.org/image/ozmdv0dyt/)
Things always seem clearer the next day. Personally I would have preferred bends rather than welds but thats just me. Great job regardless.
Well after all this time I finally got around to wiring them up!! Well after I got side tracked!!!!!!!!!
Whilst the nose cone was off I thought let look at my rad (after losing that fluid the other week) and see if I can shift it to the o/s by half-an-inch!!
I took one look at my rad cover cowl and thought thats a little tatty.
So in the stripper it had to go;
(http://s12.postimage.org/7v6cxeh7t/DSCF8498.jpg) (http://postimage.org/image/7v6cxeh7t/)
Thought I would do this in my Black skarkle metallic. Looks good,
(http://s11.postimage.org/8mjckr7kv/DSCF8500.jpg) (http://postimage.org/image/8mjckr7kv/)
(http://s18.postimage.org/mjdctboid/DSCF8499.jpg) (http://postimage.org/image/mjdctboid/)