• Welcome to Bristol Kit Car Club and Forum - BKCC.
 

News:

A big thanks to all members past and present for making the club viable for so long.

Main Menu
AIB BKCC Kit Car Insurance
Discounts For Club Members

+-Member Login or Register

Welcome, Guest.
Please login or register.
 
 
 
Forgot your password?

V6 essex getting warm

Started by danwilko, 06, April, 2014, 07:25:20 PM

Previous topic - Next topic

danwilko

After the mot pass brought her back to mine and once I stopped lots of water came out the radiator over flow pipe

Think it was my fault, didn't bleed it properly
Bled it well today and took it for a run to get new rear tyres (the free ones rub badly on the rear arch)
No water over flows this time , must have got rid of the air lock, but temp gauge got to 100c
Not sure if this is normal or if gauge doesn't  match the new thermostate
Sound normal? Have read they do get hot but just after some advice

Iancider

Sounds like she's boiling through lack of water circulation.

Hot favourites air-lock:  Undo the radiator top-hose and let it glug a bit and then top-up.  teh pressure vessel migh be too low - it should be above the radiator.  Just overflowing without overheating would be just over-filling but you do have overheating.

Mechanical thermostat failed: so the cylinder-head water is no curculating fast enough.  Take it out, drop it in boiling water and it should open fully - if not replace it and the gasket.

The fan-belt could be loose or the impellor on the water pump might have failed - rare but it can happen.  If you have a belt drive fan then the fan may be inefficient as well if the belt is slipping.

If you have an electric fan it has it has an independent temperature sensor to the guage and it might not be operating at the correct 85 degrees C. If so disconnet the wires from the sensor and make a wire link between the two and with the ignition on the fan should run.  if, not then the fan has failed rather than the switch.

Regards
Ian

benchmark51

I had to replace the fan switch a while back as it didn't kick in early enough. Could check that?
It might be a good idea to do a compression test and a cooling system pressure test as
I seem to remember V6's being a bit prone to that. Also good airflow through the rad(leaves ect).

danwilko

Thanks the replies
New fan and new radiator, fan is thermostatically controlled and is adjustable, runs fine
Did think it was the thermostat at the top of the engine so was advised to move that to help remove the air locks
Lifted header tank to high point and filled in order to remove air locks, did glug a lot and removed pipe to top of radiator to check flow and it does
New water pump was fitted when I changed the engine

Water doesn't come out the overflow now but it does feel warm in engine and radiator and it got hot during idle

Radiator is fitted at an angle and fan doesn't blow into engine if that makes a difference

Could the radiator be to small or fan not powerful enough to cool it?

Iancider

Still a few possibilities to go.

If you can find a thermometer, check the header tank temperature when it is indicating hot and compare it with the car temperature guage.  In a pressurised system the normal running temperature should be about 85 degrees.  If the gauge indicates high compared to the thermometer then you have a failed temperature sender - quite common problem on older Fords - cheap and quick to replace.

As for the fan and radiator - when hot it should run for up to three minutes to cool the engine down.  If it runs longer or continuously then it is likely the fan/radiator combination is not man enough to do the job or the water circulation is still too poor.  You could also try removing the cylinder head thermostat altogether then replacing the housing and hose.  This will give a very slow warm-up but it should not get too hot then.  That too would prove that the thermostat was not opening fully when hot.

You can check the impeller and circulation simply by starting the engine cold with top radiator hose removed - it should gush not trickle - sorry that is messy but a quick proof.

danwilko

The fan does run for a long time, just thought I had it set up wrong, will time it next time

Will check with a thermometer as well,

Will let you know the outcome

chris61

I've got an infered temp gun if you need to borrow it mate, helps pin point hot /cold spots in radiators and you can see if the sats opening without removing it

danwilko

Thanks chris61
Are u coming Sunday? Could u bring it then

chris61

sorry mate just seen this, im not sure yet, might be working on the bloody car to get it done!

danwilko

No probs
Been speaking to a few people and all have said I have the wrong radiator, for a 2 litre
New up rated radiator ordered so hopefully that will work

Just the suspension to sort out next

Powered by EzPortal
Great value Kit Car insurance. Dont forget to mention the BKCC
Discounted insurance for our members.</a></center>
			</div><!-- #main_content_section -->
		</div><!-- #content_section -->
	</div><!-- #wrapper -->
</div><!-- #footerfix -->
	<div id=