Hello all!
I have been having an absolute nightmare trying to flare... well practice test flare some lines. I have a basic Clarke set but it/i can never seem to get them center. Is there any chance anyone can loan me a proper set(flaremaster2 or equal) over the weekend so i can get these lines done? Or even better may be lend a hand and show me how the pro's do it? Beer tokens available! :)
Thanks everyone
If you bring your pipes to me I will flare them while you wait with my Pro tool.
Contribution to Tea/Coffee fund acceptable
I am working 10 - 4 on Sat
Ring 07977 948883 or PM me to confirm.
Workshop is Lordswood Farm SN16 0JZ (10 mins north of Castle Combe / 5 miles N of J 17 M4)
Thanks for the offer but the problem is some of the hard lines are quite long and bend around quite a bit and getting the length will be very hard without doing it on site. Especially when they twist around various chassis tubes some of the shorter runs would be fine but its the two that run to front and rear that will be a pain. Will keep you in mind if that's ok? just in case no one else can help and i run out of options heh
just a little bump before the weekend :)