What thread on my Girling 75 Master cylinder?

[Dixie]

Does anyone know what the thread size/type is on my Girling Master cylinder.

Plus does anyone have a remote servo they want to sell??

Ta  Mark

[Hairy Santa]

Does anyone know what the thread size/type is on my Girling Master cylinder.

Plus does anyone have a remote servo they want to sell??

Ta  Mark

I have checked all the cylinders I have which are girling 75's and they are all AF, so I would think yours would be the same

Did you drill the hole lower down - If you have 3" above the fulcrum and 5" below to the pedal , you are not even getting 2 to 1 - no wonder the clutch is hard

try the lower position if you can get the rod to line up reasonably well - you could also try a smaller diameter cylinder as well which would decrease the amount of fluid moving therefore reducing the effort, as long as it moves enough fluid to clear the clutch at the slave end

or make the slave larger

give me a ding on how you get on   

[Dixie]

Thanks Pete.

Spoke to DAX today, they think that using a smaller cylinder 0.63 not 0.75 will help.

They said that using a servo wouldn't work.  What Bo**ocks, your one on the SRV8 work well enough.

M