• Welcome to Bristol Kit Car Club and Forum - BKCC.
 

News:

Due to 100's of daily spam registrations, new member applications have been disabled. Sorry.

Main Menu
AIB BKCC Kit Car Insurance
Discounts For Club Members

+-Member Login or Register

Welcome, Guest.
Please login or register.
 
 
 
Forgot your password?

More diff. probs.

Started by paintman, 23, July, 2011, 10:47:53 PM

Previous topic - Next topic

paintman

Me and Stupott had a trundle to the scrappies today and returned with a 3.62 diff.  (we hope) for the Hood.

We managed to get the diff. in without to much hassle but when we refitted the push-in drive shafts, we found they were 1/4 inch short and would not engage with the internal diff.
splines! ???

I can get the ones out of the scrappie car so no real prob. but we are curious how this happened......any ideas?? ::)

    Tony

'The Gaffer'

How strange. Presumably the diffs are the same size?

paintman

#2
Externaly the two diffs. look the same but if you measure from the centre of the diff. through the drive shaft holes, there is a 1/4 inch difference between the two diffs. on each side ...... the old shafts fails to actually reach the splines inside due to the shaft hitting a flange on the diff. housing, which stops it going in any farther and engaging.

The correct shafts need to have a longer splined section than my old ones.

Could this be because one is a 7" diff. and the other a 71/2" maybe?

     

Sumov8

Some extracts I collectred when looking at diffs for my car:-

The term 7", 7.5" and 9" is the width across the top of the diff case where the mounting bar goes through. So measuring the distance will say which you have.
9" is the strongest, then 7.5" then 7. - but 7 is the lightest, so best to use the smallest you can.
Sierra is smaller than the Mk-3 Granada





paintman

Well that explains that, I thought it might have referred to the crown wheel inside :-[

The new diff. is a 7" still then because we managed to swap them with the no probs.

I'm picking up the shafts that were in it tomorrow, so it will be interesting to note the difference in them. ::)

    Cheers for the imfo.  Tony

'The Gaffer'

Hmmm, be interesting to see how this one works out. Same shafts should fit same sized diff I would have thought??

Hope it all goes well.

paintman


SORTED.......





No wonder the old shafts did not fit.. ::)

I think the old diff. and shafts came from a Sierra 1600 (note the difference in thickness).

'The Gaffer'


Powered by EzPortal
Great value Kit Car insurance. Dont forget to mention the BKCC
Discounted insurance for our members.</a></center>
			</div><!-- #main_content_section -->
		</div><!-- #content_section -->
	</div><!-- #wrapper -->
</div><!-- #footerfix -->
	<div id=