• Welcome to Bristol Kit Car Club and Forum - BKCC.
 

News:

Over 50,000 Posts in 4465 Topics by 611 Members! From 2009 - 2024

Main Menu
AIB BKCC Kit Car Insurance
Discounts For Club Members

+-Member Login or Register

Welcome, Guest.
Please login or register.
 
 
 
Forgot your password?

Car wont idle

Started by Grin-a-lot, 16, August, 2010, 09:02:55 PM

Previous topic - Next topic

Grin-a-lot

Just had the carbs checked at M-Tech Automotive, very helpful they were and i'd certainly recommend them.

Tuning the carbs has removed the flat spot that I had on acceleration as well as raise power to 117bhp.

The only snag now is that for some reason the car won't idle, it seems to try and sit at 1100rpm (ford crossflow) before slowly falling off and stalling.

Rather than take it back to Westbury can I adjust idle speed myself or am i likely to open up a whole world of trouble if I start tweaking?  Will adjusting the idle speed undo all the good work that the garage did in setting up the carbs?

All I want to do is get the car idling at approx 1100 rpm.  I'm running twin Weber 40 DCOEs.


Bulldog Bri

One way to play with the carbs is to mark on the idle screw with a fine marker pen (sharpie would do) and a mark on the housing before you start fiddling, count how many times you do any turning and which way in a note book and see what difference it makes if it isn't going right, then you should be able to put it back to how it was  ;D

Just take your time and be clear in your notes.

8)

David H

Call M Tech and tell them your problem.

Grin-a-lot

Thanks for the advice; i'd done a bit of homework and thought (hoped) it might just be the idle speed screw.  If it was then I was planning on fixing it myself rather than drive back to Westbury just for tweaking a screw.  If you'd have suggested something more serious then it certainly would've gone back rather than me nause it up.

I called m-tech to see what they said and they are sure it's the idle screw so I'm going to have a play; if it's still squiffy then it'll go back.

'The Gaffer'


Grin-a-lot

All good thanks!  Tuned the carbs and its made quite a difference to the car, it was running a bit rich and they weren't balanced.  The flat spot that I found when accelerating is now gone so all good there!  Managed to get the car from 106 to 117bhp with tuning and a peak of 120ftlb torque.  I'm not too bothered that its not at the 135bhp that Vulcan state on their website; could be any number of reasons.  At least I know the engine is running correctly.

As for the idling, it appears his final "fine-tuning" tweak at the very end was one too many and the idle was set too low.  I checked with m-tech prior to fiddling but they advised to wind the screw in a bit so I did and she's now idling merrily at 1000 rpm.  I've never looked at carbs before and wasn't sure whether the idle speed screw would mess up the mixture settings/balance etc but now I understand how they work a bit more so an all round good result!


'The Gaffer'

Excellent. Nothing better than getting to know your own car :)

Powered by EzPortal
Great value Kit Car insurance. Dont forget to mention the BKCC
Discounted insurance for our members.</a></center>
			</div><!-- #main_content_section -->
		</div><!-- #content_section -->
	</div><!-- #wrapper -->
</div><!-- #footerfix -->
	<div id=