• Welcome to Bristol Kit Car Club and Forum - BKCC.
 

News:

A big thanks to all members past and present for making the club viable for so long.

Main Menu
AIB BKCC Kit Car Insurance
Discounts For Club Members

+-Member Login or Register

Welcome, Guest.
Please login or register.
 
 
 
Forgot your password?

Westfield Clearance for Trolley Jack

Started by rigel, 28, June, 2010, 10:50:58 AM

Previous topic - Next topic

rigel

Hi,

Can anyone tell me the chassis clearance to the ground?

I need to make sure I buy a trolley jack that isn't too high.

Paul

'Mendip Wurzel'

I guess the clearance at the front is dependant on how you adjust the suspension. I would think 75mm clearance is about as low as you would want to go, a lot seem to settle for around 90mm.

Most trolley jacks are too high and the ones that do go lower are expensive. Machine Mart do one that goes down to 80mm but even that may not be enough. I expect there are other lower ones at a price.

I went through the same decision making process and now use a very low sissor jack to lift that first inch or so and then slide under the trolley jack. Probably not the best solution but it was the cheapest.

rigel

You've confirmed my suspicion - thanks.

I've also had to factor in getting her off some fairly high axle stands after the build - reckon I'll go for a sturdier higher lift trolley jack and deal with the clearance problem as you suggest.

Thanks.

Paul

Bulldog Bri

Either that or build some small ramps ( a couple of lines of blocks set at the right width, with a slope leading on then trolley jack from there, normally the rear of the car is set around 25mm higher than the front (learnt that at the corner clinic  ;) ) so lifting the back won't be so hard.

Just an idea  :D

8)

Quarrycars


YellaBelly

I think the rescue services use them so they must be pretty useful.

Powered by EzPortal
Great value Kit Car insurance. Dont forget to mention the BKCC
Discounted insurance for our members.</a></center>
			</div><!-- #main_content_section -->
		</div><!-- #content_section -->
	</div><!-- #wrapper -->
</div><!-- #footerfix -->
	<div id=